![]() Open the switch door, and move the power switch to on. Before we get to that, remember to start with the basic setup of your device. Programming a digital timer switch is relatively simple. Now that the switch is installed, let’s go over programming. If everything is in working order, you’re finished. Use your screwdriver once more for this process. Lastly, secure the new switch to the wall.The black wire should be attached to your hot wire, the red to your load wire, and the green to your ground wire. The white wire of the timer switch will need to connect to the neutral wires in your switch box, typically it will be a bundle of white wires capped off with a wire connector. Each timer switch comes with a white, black, red, and green wire. Connect the wires to your timer switch.Check your switch box for a bundle of white wires capped off with a wire connector and that will be your Neutral wires. One of the conductor wires will be your Hot wire and the other will be your Load wire. Use a voltage tester to identify your Hot wire. “ The existing light switch should have 3 wires connected, 2 conductors(could be black or white) wires and a Ground wire. If so, use the wire stripper to cut off insulation for newer, more fresh wiring. ![]() The receptacle should have a white neutral wire–which is required–along with a “load” wire, “hot” wire, and “ground” wire. You might simply pull wires out of a push-wire installation, or use a screwdriver to loosen screws that have wires wrapped around them. After removing the switch, disconnect any wires attached to it as well. Use a Phillips head screwdriver to release any screws keeping it attached. Remove the existing switch from the wall.Use a voltage tester to make sure all current is gone. This is an important safety consideration, as failing to do this could mean harmful or deadly electrocution. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |